Adjustable W2113324411 Automobile Control Arms Mercedes E Class
Suspension Arm / Control Arm
Mercedes-benz E class W211
Air suspension system
Guangzhou zhou / Shen zhen / Ning bo
Normally 10--20 days after order confirmed
* We have the advanced machine, skilled employee to guarantee the
nice quality. Supply full range of air suspension for car :
- Air shock absorber / air suspension shock
- Air compressor pump
- Mercedes-Benz air suspension repair kits
- BMW air suspension repair kits
- Audi air suspension repair kits
- Land Rover air suspension repair kits
- Hose crimping machine and dies
- Air suspension kits /air suspension spring
- Hydraulic shock absorber
- Air suspension valve / air distribution block
- Power steering pump
- Automobile control arms
- Transmission filters
- Steering rack
* What is automobile control arm ?
The control arm helps position the vertical center line of the
wheel and allows for up and down movement of the wheel in relation
to the vehicle's body.
*Symptoms of Wear or Failure
Suspension may make a squeaking and/or knocking noise when going
Vehicle may wander
Uneven tire wear
*Related Repair Advice
In many cases, the control arm must be replaced in order to replace
Replacing the control arm may affect the alignment's settings. We
recommend a four-wheel alignment when a control arm is replaced.
* How to get the right item :
Method 1 : Show me the chassis No. and engine No.
Method 2 : Show me the OEM No. or Parts No.
Method 3: Show me the photo
We have models as below
E30 E36 E46 E90 F30
W202 W203 W204
E34 E39 E60 E63 F10
W124 W210 W211 W212
E32 E38 E65/E66 F01 F02
W140 W220 W221
* More information about control arm
In automotive suspension, a control arm, also known as an A-arm, is
a hinged suspension link between the chassis and the suspension
upright or hub that carries the wheel.
The inboard (chassis) end of a control arm is attached by a single
pivot, usually a rubber bushing. It can thus control the position
of the outboard end in only a single degree of freedom, maintaining
the radial distance from the inboard mount. Although not
deliberately free to move, the single bushing does not control the
arm from moving back and forth; this motion is constrained by a
separate link or radius rod.
This is in contrast to the wishbone. Wishbones are triangular and
have two widely spaced inboard bearings. These constrain the
outboard end of the wishbone from moving back and forth,
controlling two degrees of freedom, and without requiring
Most control arms form the lower link of a suspension. A few
designs use them as the upper link, usually with a lower wishbone.
The additional radius rod is then attached to the upper arm.
Not only we are able to supply large quantity order, but also we
can organize small quantity complex order as well.
* Contact information :
Contact number: Ivy Lee
Mobile number / WHATSAPP / WECHAT: +86 13609036725